![]() Push in the clip and slide the arm on the connection down, releasing it from the module. ![]() Turn the module over and release the wiring harness. Compress the clip and push the unit forward until it releases from the dash. There is another one on the other side of the unit. if you replaced the switch but didn't clear the code the light will be still on because the. when light comes back on scan it again and that is going to be your true problem. after you clear the codes drive it for a while. in this type of cars you cannot clear codes with a regular obd II it has to be the factory scanner or similar. Gearbox and other transmission components (EGS, ETC, FTC)Īll activity module (AAM), Radio (RD), ICS. Look inside and you will see one metal clip holding the module in place. SOURCE: BAS ASR problem ok, first you have to clear the codes. I could take it to the dealer and it would cost me what my car cost to get it replaced. You have to insert a tool (like the included Allen wrench) beside the rear headrest to release its spring lock. If a traction control sensor fails it will cause the warning lights to turn on and the cruise control to stop working. The cruise control relies on the signals from the traction control module in order to regulate the vehicle speed. Ignition control (EZS), air-conditioner (KLA), PTS, safety systems (Airbag, SRS, AB) and some otherĬAN-High (including AirBag system in W203, W209, W220, W240, R230, С215 after 2004y) Hey guys and gals, :smile I have this 1999 Mercedez C230 that has a broken key and Electronic Ignition Switch (EIS). If that doesnt work, then youll need to lower them manually. The ABS, BAS and ESP lights are all part of the traction control system.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |